Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS SPECIFICATIONS
| The monitor will run whenever the following DTCs are not present | None |
| Transmission counter gear speed | 300 rpm or more |
| Engine condition | Running |
| Time after ignition switch ON | 3 sec. or more |
| Either of the following conditions A and B is met: | |
| Conditions A: | |
| Time after PNP switch ON to OFF | 2 sec. or more |
| ECT and ECT sensor | ECT is 20° C (68° F) or more and ECT sensor dose not malfunctions (P0115 or P0116) |
| Conditions B: | |
| Time after PNP switch ON to OFF | 30 sec. or more |
| ECT and ECT sensor | ECT is less than 20°C (68° F) or ECT sensor fail detected (P0115 or P0116) |