Precaution For Transfer Assembly And Transfer Control Unit Replacement: Notes

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

When replacing transfer assembly or transfer control unit, check the 4WD shift indicator lamp as follows.

Turn ignition switch ON.
Check 4WD shift indicator lamp is turned ON for approximately 1 second.
- If OK, the position between transfer assembly and transfer control unit is correct.
- If NG, the position is different between transfer assembly and transfer control unit.
  Adjust the position between transfer assembly and transfer control unit. See METHOD FOR POSITION ADJUSTMENT that follows.