LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 931 (Wiper & Washer) >> Symptom Diagnosis >> Wiper And Washer System Symptoms >> Symptom Table

Symptom Table

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Perform the self-diagnosis with CONSULT before performing the diagnosis by symptom. Perform the diagnosis by DTC if DTC is detected.
Symptom Probable malfunction location Inspection item
Front wiper does not operate. HI only
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
  • IPDM E/R
  • Harness between IPDM E/R and front wiper motor
  • Front wiper motor
Front wiper motor (HI) circuit Refer to "COMPONENT FUNCTION CHECK ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
LO and INT
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
  • IPDM E/R
  • Harness between IPDM E/R and front wiper motor
  • Front wiper motor
Front wiper motor (LO) circuit Refer to "COMPONENT FUNCTION CHECK ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
INT only
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
HI, LO, and INT SYMPTOM DIAGNOSIS
"FRONT WIPER DOES NOT OPERATE"
Refer to "DIAGNOSIS PROCEDURE ".
Front wiper does not stop. HI only
  • Combination switch (wiper and washer switch)
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
IPDM E/R -
LO only
  • Combination switch (wiper and washer switch)
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
IPDM E/R -
INT only
  • Combination switch (wiper and washer switch)
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
Front wiper request signal
  • BCM 
  • IPDM E/R
IPDM E/R DATA MONITOR "FR WIP REQ"
Front wiper does not operate normally. Intermittent adjustment cannot be performed.
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
BCM -
Intermittent control linked with vehicle speed cannot be performed. Check the vehicle speed detection wiper setting. Refer to "WIPER: CONSULT FUNCTION (BCM - WIPER) ".
Wiper is not linked to the washer operation.
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
BCM -
Does not return to stop position (Repeatedly operates for 10 seconds and then stops for 20 seconds. After that, it stops the operation).
  • IPDM E/R
  • Harness between IPDM E/R and front wiper motor
  • Front wiper motor
Front wiper auto stop signal circuit Refer to "COMPONENT FUNCTION CHECK ".
Rear wiper does not operate. ON only
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
INT only
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
ON and INT
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
  • BCM 
  • Harness between rear wiper motor and BCM
  • Harness between rear wiper motor and ground
  • Rear wiper motor
  • Glass hatch ajar switch
Rear wiper motor circuit Refer to "COMPONENT FUNCTION CHECK ".
Rear wiper does not stop. ON only
  • Combination switch (wiper and washer switch)
  • BCM 
Rear wiper motor circuit Refer to "COMPONENT FUNCTION CHECK ".
INT only
  • Combination switch (wiper and washer switch)
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
Rear wiper does not operate normally. Wiper is not linked to the washer operation.
  • Combination switch (wiper and washer switch)
  • Harness between rear wiper motor and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
BCM -
Rear wiper does not return to the Stop position (Stops after a five-second operation).
  • BCM 
  • Harness between rear wiper motor and BCM
  • Rear wiper motor
Rear wiper auto stop signal circuit Refer to "COMPONENT FUNCTION CHECK ".
Rear wiper stops after operating for five seconds when ignition switch is turned ON.
Washer motor does not operate. Washer motor does not operate when washing the windshield.
  • Combination switch (wiper and washer switch)
  • Harness between combination switch (wiper and washer switch) and BCM
  • BCM 
Combination switch (wiper and washer switch) Refer to "SYMPTOM TABLE ".
  • Harness between BCM and front and rear washer motor
  • Front and rear washer motor
Front and rear washer motor circuit Refer to "DIAGNOSIS PROCEDURE ".