LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 904 (Seats) >> Ecu Diagnosis Information >> Third Row Power Folding Seat Control Unit >> DTC Index

DTC Index

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To initiate a chime code sequence cycle, turn the ignition switch ON and OFF 3 times within 5 seconds. The first digit will chime, then a pause, followed by the second digit. For example, a code 13 will have 1 chime, followed by a pause, and then 3 chimes. The third row power folding seat control unit will clear all codes that have been corrected after 255 ignition cycles.
DTC Malfunction Service Procedure
11 LH seat has traveled past normal fold down position
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Check third row power folding seat motor LH Hall signal and ground circuits. Refer to "THIRD ROW POWER FOLDING SEAT STOPS SHORT OF IT'S FULLY UP OR DOWN POSITION ".
  3. Replace third row power folding seat motor LH. Refer to "EXPLODED VIEW ".
12 LH seat has traveled past normal fold up position
13 LH seat actuation cycle has taken too long and timed out
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Check third row power folding seat motor LH motor circuits. Refer to "ONLY ONE THIRD ROW POWER FOLDING SEAT WILL OPERATE ".
  3. Replace third row power folding seat motor LH. Refer to "EXPLODED VIEW ".
14 Third row power folding seat control unit NVRAM data for LH seat position has been corrupted Replace third row power folding seat control unit. Refer to "REMOVAL AND INSTALLATION - POWER SEAT CROSS BEAM ".
15 Power supply to third row power folding seat control unit has been interrupted during LH seat fold up/down cycle
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Replace third row power folding seat control unit. Refer to "REMOVAL AND INSTALLATION - POWER SEAT CROSS BEAM ".
21 RH seat has traveled past normal fold down position
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Check third row power folding seat motor RH Hall signal and ground circuits. Refer to "THIRD ROW POWER FOLDING SEAT STOPS SHORT OF IT'S FULLY UP OR DOWN POSITION ".
  3. Replace third row power folding seat motor RH. Refer to "EXPLODED VIEW ".
22 RH seat has traveled past normal fold up position
23 RH seat actuation cycle has taken too long and timed out
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Check third row power folding seat motor RH motor circuits. Refer to "ONLY ONE THIRD ROW POWER FOLDING SEAT WILL OPERATE ".
  3. Replace third row power folding seat motor RH. Refer to "EXPLODED VIEW ".
24 Third row power folding seat control unit NVRAM data for RH seat position has been corrupted Replace third row power folding seat control unit. Refer to "REMOVAL AND INSTALLATION - POWER SEAT CROSS BEAM ".
25 Power supply to third row power folding seat control unit has been interrupted during RH seat fold up/down cycle
  1. Perform Preliminary Check. Refer to "PRELIMINARY CHECK ".
  2. Replace third row power folding seat control unit. Refer to "REMOVAL AND INSTALLATION - POWER SEAT CROSS BEAM ".
33 System normal or END of chime codes -
scientia non olet · About LEMON Manuals