Third Row Power Folding Seat Stops Short of it's Fully Up or Down Position

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. PRELIMINARY CHECK 

   Perform preliminary check. Refer to "PRELIMINARY CHECK ".

   Are inspection results normal? 

   YES: GO TO 2.

   NO: Perform repairs as necessary.

2. CHECK HISTORY 

   Check to see if a previous normal seat folding operation was interrupted due to low voltage condition.

   Was voltage interrupted? 

   YES: Perform learn procedure by operating affected seat until seat reaches full open/closed position.

   NO: GO TO 3.

3. THIRD ROW POWER FOLDING SEAT MOTOR 
   1. Turn ignition switch OFF.
   2. Disconnect third row power folding seat motor harness connector and third row power folding seat control unit harness connector.
   3. Check continuity between third row power folding seat motor harness connector B403 (LH) or B426 (RH) terminals 1, 2 and third row power folding seat control unit harness connector terminals 10, 15 (LH) or 9, 15 (RH).

      Terminals				Continuity
      Connector	Terminal	Connector	Terminal
      A: B401	9 (RH)	C: B426 (RH)	1	Yes
      	10 (LH)	C: B403 (LH)
      B: B402	15 (LH/RH)	C: B426 (RH)	2
      		C: B403 (LH)

      Fig 1: Checking Continuity Between Third Row Power Folding Seat Motor Harness Connector B403 (LH) Or B426 (RH) Terminals 1, 2 And Connector Terminals 10, 15 (LH) Or 9, 15 (RH)

      Courtesy of NISSAN NORTH AMERICA, INC.

      Is there continuity? 

      YES: Replace affected third row power folding seat motor. Refer to "EXPLODED VIEW ".

      NO: Repair circuits as necessary.