Removal and Installation of Front Brake Piping and Brake Hose: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Install brake hose by aligning with the protrusion on cylinder body, then install the union bolt (A) and new copper sealing washers (1) and tighten to specification. Refer to "HYDRAULIC CIRCUIT ".
CAUTION: Do not reuse copper sealing washers.

Fig 1: Identifying Copper Sealing Washers And Union Bolt
Courtesy of NISSAN NORTH AMERICA, INC.
Insert brake hose end through bracket, then secure it to bracket with lock plate.
Install brake tube to brake hose, then tighten the flare nut using a suitable tool. Refer to "HYDRAULIC CIRCUIT ".

Fig 2: Identifying Brake Tube, Brake Hose, Lock Plate And Flare Nut
Courtesy of NISSAN NORTH AMERICA, INC.
Refill brake fluid and bleed air. Refer to "BLEEDING BRAKE SYSTEM ".
Install front wheel and tire. Refer to "ROTATION ".