LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 898 (Meter, Warning Lamp & Indicator) >> Symptom Diagnosis >> The Parking Brake Release Warning Continues Displaying, Or Does Not Display >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK PARKING BRAKE WARNING LAMP OPERATION 
    1. Start engine.
    2. Monitor "BRAKE" warning lamp while applying and releasing the parking brake.

      BRAKE warning lamp 

      Parking brake applied: ON 

      Parking brake released: OFF 

      Is the inspection result normal? 

      YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

      NO: GO TO 2

  2. CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Check the parking brake switch signal circuit. Refer to "DIAGNOSIS PROCEDURE ".

      Is the inspection result normal? 

      YES: GO TO 3

      NG: Repair harness or connector.

  3. CHECK PARKING BRAKE SWITCH UNIT 

    Perform a unit check for the parking brake switch. Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

    NO: Replace parking brake switch.