LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Abs With EBD System - Diagnostics) >> Abs With EBD System (April, 2003) >> TS Terminal Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT DLC3 TERMINAL VOLTAGE (Ts TERMINAL) 
    1. Turn the ignition switch to ON.
    2. Measure voltage between terminals Ts and CG of DLC3.

      OK: 

      Voltage: 10 - 14 V 

      Fig 1: Identifying Terminals Ts And CG Of DLC3
      G02860873Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK: Go to step   3 
    2. NG: GO TO NEXT STEP. 
  2. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) 
    1. Check for open and short circuit in harness and connector between terminal CG of the DLC3 and body ground (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: GO TO NEXT STEP. 
  3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) 
    1. Check for open and short circuit in harness and connector between terminal Ts of the DLC3 and skid control ECU (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (See  TERMINALS OF ECU  ) 
scientia non olet · About LEMON Manuals