Screen Noise Automatic Adjustment
HINT:
- This adjustment is performed to reduce noise when screen noise occurs upon replacing the multi-display, the navigation ECU or the television camera ECU.
- Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.
- Perform both procedures below when the multi-display is replaced.
- When either the multi-display or the navigation ECU is replaced:
- Turn the ignition switch to the ACC position and wait for at least 6 seconds to activate the diagnostic mode (see DIAGNOSTIC START-UP/FINISH ).
- Select "Navigation Check" from the "Diagnosis MENU" screen.
- The screen enters "Navigation Check" with a beeping sound. Adjustment is completed when the completion mark is displayed.
- Cancel the diagnostic mode (see DIAGNOSTIC START-UP/FINISH ).
- When either the multi-display or the television camera ECU is replaced:
- Turn the ignition switch to the ACC position and wait for at least 6 seconds to activate the diagnostic mode (see DIAGNOSTIC START-UP/FINISH ).
- Select "Camera Check" from the "Diagnosis MENU" screen.
- Adjustment is completed when the steering angle setting screen is displayed.
- Cancel the diagnostic mode (see
DIAGNOSTIC START-UP/FINISH ).
HINT:
- If the automatic adjustment is not performed (only step 2) only upon replacing the multi-display, a beeping sound can be heard for 3 seconds (while the initial screen is displayed) after turning the ignition switch to the ACC position.
- Perform the automatic adjustment again if a beeping sound can be heard within 3 seconds.