LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 99 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0133: Heated Oxygen Sensor No. 1 Circuit Slow Response (Bank 1 Sensor 1) Or DTC P0153: Heated Oxygen Sensor No. 1 Circuit Slow Response (Bank 2 Sensor 1) >> Diagnosis & Repair

Diagnosis & Repair

WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. If other DTCs are displayed, diagnose and repair those DTCs first and retest system. If only DTC P0133 and/or P0153 are displayed, go to next step.
  2. Connect scan tool to Data Link Connector (DLC) No. 3. See Figure. Start engine and increase engine speed to 2500 RPM for about 90 seconds. Let engine idle. Using scan tool, monitor each heated oxygen sensor No. 1 output voltage. Voltage should alternate repeatedly between less than .4 volt and more than .55 volt. See Figure. If voltage is as specified, go to step  7. If voltage is not as specified, go to next step.
  3. Check for open or short in wiring between ECM and heated oxygen sensors No. 1. See ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL. If problem exists, repair wiring as necessary. If problem does not exist, go to next step.
  4. Ensure oil dipstick, oil filler cap, PCV system and all other air induction system components are intact and operating properly. If problem exists, repair as necessary. If problem does not exist, go to next step.
  5. Check fuel pressure. See FUEL SYSTEM in BASIC DIAGNOSTIC PROCEDURES article. If fuel pressure is not within specification, repair as necessary. If fuel pressure is within specification, go to next step.
  6. Check fuel injectors. See FUEL SYSTEM in SYSTEM & COMPONENT TESTING - LX470 article. If problem exists, repair as necessary. If problem does not exist, replace appropriate heated oxygen sensor No. 1.
  7. Perform test drive confirmation, then go to next step. See TEST DRIVE CONFIRMATION  under DTC P0130, DTC P0150, DTC P2195, DTC P2196, DTC P2197 OR DTC P2198.
  8. Clear and recheck for DTCs. If DTC P0133 and/or P0153 is displayed again, replace ECM. If neither DTC P0133 or P0153 is not displayed again, problem is intermittent. Check component and ECM connections.
scientia non olet · About LEMON Manuals