Compressor And Magnetic Clutch: Installation

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

5VZ-FE engine: Install compressor.
1. Install the compressor with the 4 bolts.
  Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
2. Connect the connector.
2UZ-FE engine: Install compressor.
1. Install the compressor with cooler bracket with the 4 bolts and nut.
  Torque: 25 N.m (250 kgf.cm, 18 in.lbf)
2. Connect the connector.
5VZ-FE engine: Connect discharge and suction hoses.
1. Connect the both hoses with the 2 bolts.
  Torque: 10 N.m (100 kgf.cm, 7 in.lbf)
  
  CAUTION: Hose should be connected immediately after the caps have been removed.
  
  NOTE: Lubricate 2 new O-rings with compressor oil and install them to the hoses.
2UZ-FE engine: Connect discharge and suction hoses.
1. Connect the both hoses with the 2 nuts.
  Torque: 10 N.m (100 kgf.cm, 7 in.lbf)
  
  CAUTION: Hose should be connected immediately after the caps have been removed.
  
  NOTE: Lubricate 2 new O-rings with compressor oil and install them to the hoses.
Install and check drive belt. See INSTALLATION and ON-VEHICLE INSPECTION .
5VZ-FE engine: Install engine under cover.
Connect negative (-) terminal cable to battery.
Evacuate air from refrigeration system.
Charge system with refrigerant.
Specified amount: 600 +/- 50 g (21.16 +/- 1.76 oz.)
Inspect for leakage of refrigerant.
1. Using a gas leak detector, check for leakage of refrigerant. If there is leakage, check the tightening torque at the joints.