Removal & Installation (ECHO)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure ignition is off. Remove No. 2 cylinder head cover located on top of engine, above ignition coils and valve cover. Remove air cleaner assembly for access to Engine Coolant Temperature (ECT) sensor. See ENGINE COOLANT TEMPERATURE SENSOR LOCATION table. Disconnect electrical connector at ECT sensor.
- Drain cooling system. Remove ECT sensor and gasket. To install, reverse removal procedure using NEW gasket. Reinstall air cleaner assembly and No. 2 cylinder head cover. Fill cooling system.