LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Controls - Removal & Installation, Overhaul 4 Cylinder) >> Computerized Engine Controls >> Engine Control Module >> Removal & Installation (MR2)

Removal & Installation (MR2)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.

Ensure ignition is off. Note location of Engine Control Module (ECM). See ECM LOCATION  table. Remove luggage compartment lids, luggage compartments, quarter trim panels, lower trim covers, partition board and cover for access to ECM. See Figure. For additional information on removal of luggage compartment components, see FUEL PUMP  under FUEL SYSTEMS. Remove ECM. To install, reverse removal procedure.