Land Cruiser, Sequoia & Tundra 4.7L V8
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Camshaft position sensor is located behind driver's side upper timing belt cover with electrical connector near front of upper timing belt cover. See Fig 1. On Land Cruiser, remove intake manifold cover located on top of engine, above intake manifold for access to electrical connector for camshaft position sensor.
- On all models, disconnect electrical connector at camshaft position sensor. Using ohmmeter, check resistance between electrical terminals on electrical connector for camshaft position sensor. See Fig 1.
- Ensure camshaft position sensor resistance is within specification. See CAMSHAFT POSITION SENSOR RESISTANCE table. Replace camshaft position sensor if resistance is not within specification. See CAMSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - V6 & V8 article. Reinstall electrical connector for camshaft position sensor.