Tacoma, Tundra 3.4L V6 & 4Runner
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect electrical connector for camshaft position sensor located near upper radiator hose. See Fig 1. Camshaft position sensor is located behind upper timing belt cover, near passenger's side camshaft sprocket.
- Using ohmmeter, check resistance between electrical terminals on electrical connector for camshaft position sensor. See Fig 1. Ensure camshaft position sensor resistance is within specification. See CAMSHAFT POSITION SENSOR RESISTANCE table. Replace camshaft position sensor if resistance is not within specification. See CAMSHAFT POSITION SENSOR
under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - V6 & V8 article. Reinstall electrical connector for camshaft position sensor.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CAMSHAFT POSITION SENSOR RESISTANCE
| Application |
Ohms |
| Avalon & Camry |
| Cold |
835-1400 |
| Hot |
1060-1645 |
| Camry Solara |
| Denso Sensor |
| Cold |
835-1400 |
| Hot |
1060-1645 |
| Wabash Sensor |
| Cold |
1690-2560 |
| Hot |
2145-3010 |
| Highlander, Land Cruiser, Sequoia, Sienna, Tacoma, Tundra & 4Runner |
| Cold |
835-1400 |
| Hot |
1060-1645 |