LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Basic Diagnostic Procedures - 4-Cylinder) >> Ignition Systems >> Camshaft Position Sensor >> MR2

Camshaft Position Sensor: MR2

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Camshaft position sensor may also be referred to Variable Valve Timing (VVT) sensor. Camshaft position sensor is located just above intake manifold on cylinder head, at flywheel end of engine. See Figure.
  2. Manufacturer recommends removing camshaft position sensor from cylinder head before checking the resistance. Remove camshaft position sensor. See CAMSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - 4-CYLINDER article.
  3. Using ohmmeter, check resistance between electrical terminals on camshaft position sensor. Ensure camshaft position sensor resistance is within specification. See CAMSHAFT POSITION SENSOR RESISTANCE  table. Replace camshaft position sensor if resistance is not within specification. Reinstall camshaft position sensor.
scientia non olet · About LEMON Manuals