LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Controls - On-Vehicle Adjustments - V6 & V8) >> Throttle Position Sensor >> V6 >> Avalon, Camry Solara, Sienna, Tacoma & Tundra

Avalon, Camry Solara, Sienna, Tacoma & Tundra

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Manufacturer does not list procedure for Throttle Position (TP) sensor adjustment. Only information available is for checking resistance of TP sensor.
  2. Disconnect electrical connector from TP sensor. Note electrical terminals on TP sensor. See Figure-Figure . Apply vacuum to throttle opener.
  3. Using ohmmeter, check resistance between specified terminals in relation to throttle position. See THROTTLE POSITION SENSOR RESISTANCE  table. Replace components as necessary if resistance is not within specification.
scientia non olet · About LEMON Manuals