LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls - On-Vehicle Adjustments - 4-Cylinder) >> Throttle Position Sensor >> CAMRY & CAMRY SOLARA

CAMRY & CAMRY SOLARA

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Manufacturer does not list procedure for Throttle Position (TP) sensor adjustment. Only information available is for checking resistance of TP sensor.
  2. Disconnect 6-pin electrical connector from throttle body for TP sensor. Using ohmmeter, check resistance between VC and E2 terminals on throttle body for TP sensor. See Figure. Replace throttle body assembly if resistance is not within specification. SeeTHROTTLE POSITION SENSOR RESISTANCE  table.
scientia non olet · About LEMON Manuals