LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls - Basic Diagnostic Procedures - 4-Cylinder) >> Ignition Systems >> Crankshaft Position Sensor >> Prius

Crankshaft Position Sensor: Prius

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS .
  1. Remove passenger's side engine cover for access to crankshaft pulley. Disconnect crankshaft position sensor electrical connector at crankshaft position sensor. Crankshaft position sensor is located on front of engine, near crankshaft pulley. See Figure.
  2. Using ohmmeter, check resistance between electrical terminals on crankshaft position sensor. Ensure crankshaft position sensor resistance is within specification. See CRANKSHAFT POSITION SENSOR RESISTANCE  table. Replace crankshaft position sensor if resistance is not within specification. See CRANKSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL & INSTALLATION - 4-CYLINDER article. Reinstall crankshaft position sensor electrical connector and passenger's side engine cover.
scientia non olet · About LEMON Manuals