LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2000 >> 4Runner Base, 4WD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical - 2.4L, 2.7L >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Ensure all sealing surfaces are clean. Apply grease to seal lip of oil seal. Using Oil Seal Installer (SST 09223-15030), install oil seal in crankshaft rear oil seal housing until oil seal is even with housing surface.
  2. On A/T models, apply Loctite to flywheel/drive plate bolt threads before installing. On M/T models, use NEW bolts when installing flywheel/drive plate. On all applications, tighten flywheel/drive plate bolts to specification in a crisscross pattern. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals