Diagnostic Procedure
- Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Measure resistance between passenger-side air bag squib harness connector Yellow/Red wire (circuit P+) and Yellow/Green wire (circuit P-). See WIRING DIAGRAMS . If resistance is less than one ohm, go to next step. If resistance is more than one ohm, repair or replace harness or connector between passenger-side air bag module and air bag sensor assembly.
- Reconnect air bag sensor assembly connector C16 to air bag sensor assembly. Connect jumper wire between passenger-side air bag squib harness connector Yellow/Red wire (circuit P+) and Yellow/Green wire (circuit P-). Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES under DIAGNOSIS & TESTING. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES under DIAGNOSIS & TESTING. If DTC 54 is not displayed, go to next step. If DTC 54 is displayed, replace air bag sensor assembly.
- Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect passenger-side air bag module connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES under DIAGNOSIS & TESTING. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES under DIAGNOSIS & TESTING. If DTC 54 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If DTC 54 is displayed, replace passenger-side air bag module.