Transmission (Pickup 4WD W/3.0L V6 & 1995 4Runner 4WD W/V6)

1. Remove transmission oil pan drain plugs from transmission. See Fig 1. Allow fluid to fully drain. If replacing transmission oil strainer, remove transmission oil pan and gasket.
   CAUTION: When removing transmission oil strainer, note bolt size and length for reassembly reference.
2. Remove bolts, transmission oil strainer and gasket (if equipped). Thoroughly clean transmission oil pan. Using NEW gasket (if equipped), install transmission oil strainer. Install and tighten bolts to specification. See TORQUE SPECIFICATIONS .
3. Using NEW gasket, install transmission oil pan (if removed). Install and tighten bolts to specification See TORQUE SPECIFICATIONS . Fill transmission through dipstick tube to specified capacity using recommended fluid. See RECOMMENDED FLUID  under LUBRICATION.
4. Ensure vehicle is on a level surface. Apply parking brake. Start engine and apply brakes. Move gearshift from Park through Low and back to Park.
5. Check fluid level on transmission dipstick. Add proper type fluid so fluid level is at the COOL range marked on the dipstick. Operate vehicle to normal operating temperature and recheck. See CHECKING FLUID LEVEL  under LUBRICATION.

Fig 1: Identifying Transmission Oil Pan Drain Plugs (Pickup 4WD With 3.0L V6 & 1995 4Runner 4WD With V6)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002