LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 1993 >> Paseo Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Overhaul - A-241E/H/L & A-243E) >> On-Vehicle Service >> Left Side Gear Shaft Seal (A-241H) >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1994 Toyota MR2, 1993 Toyota MR2, 1993 Toyota Celica, 1992 Toyota MR2, and 1992 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove dust cover and fender apron seal. Drain gear oil. Remove axle shaft. Using Remover/Installer (09520-32012), remove side gear shaft. Remove side bearing retainer. Using Puller (09308-00010), remove seal from retainer.
  2. To install, use Replacer Set (09608-30022) to press new seal into retainer. Seal should be recessed .020" (0.50 mm) when installed.
  3. Coat lip of seal with grease. Install side bearing retainer. Tighten retainer bolts to correct specification. See TORQUE SPECIFICATIONS .
  4. Using Remover/Installer (09520-32012), install side gear shaft until shaft contacts pinion shaft. Install snap ring. Install drive shaft. Ensure drive shaft cannot be pulled out. Fill differential with ATF. Install fender apron seal and dust cover.
scientia non olet · About LEMON Manuals