Torque Specifications
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1994 Toyota MR2, 1993 Toyota MR2, 1993 Toyota Celica, 1992 Toyota MR2, and 1992 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (A-241H)
| Application | Ft. Lbs. (N.m) |
|---|---|
| Countershaft-To-Driven Gear Nut | 116 (157) |
| Drive Plate-To-Crankshaft Bolts | 61 (83) |
| Extension Housing-To-Driven Pinion Bearing Cage Bolt | 18 (25) |
| Oil Cooler Pipes | 25 (34) |
| Oil Pump-To-Transaxle Case Bolts | 16 (22) |
| Ring Gear-To-Differential Case Bolts | 71 (97) |
| Torque Converter-To-Drive Bolts | 20 (27) |
| Transaxle Housing-To-Case Bolts | 21 (29) |
| Transaxle Housing-To-Engine Bolts (12-mm) | 47 (64) |
| Transaxle Rear Cover-To-Case Bolts | 21 (29) |
| Transfer Case Driven Pinion Lock Nut | 72-159 (98-216) |
| Transfer Right Case Bolts | 32 (44) |
| Transfer Right Case Retainer Bolts | 18 (25) |
| INCH Lbs. (N.m) | |
| Accumulator Cover-To-Case Bolts | 89 (10) |
| Governor Body Adapter Bolts | 89 (10) |
| Governor Cover Bracket Bolts | 115 (13) |
| Manual Detent Spring-To-Case Bolts | 89 (10) |
| Neutral Start Switch-To-Case Bolts | 48 (5.4) |
| Neutral Start Switch-To-Manual Valve Shaft Nut | 61 (6.9) |
| No. 2 Pressure Regulator Valve Body-To-Upper Valve Body Bolts | 57 (6.4) |
| Oil Pan Bolts | 44 (5.0) |
| Oil Pump Body-To-Stator Shaft Bolts | 89 (10) |
| Oil Strainer-To-Valve Body Bolts | 89 (10) |
| Oil Tube Bracket Bolts | 89 (10) |
| Parking Lock Pawl Stopper Plate Bolts | 65 (7.4) |
| Sensor Adapter Bolts | 89 (10) |
| Sensor Cover Bracket Bolts | 115 (13) |
| Solenoid-To-Lower Valve Body Bolts | 89 (10) |
| Speed Sensor-To-Case Bolts | 89 (10) |
| Testing Plug | 65 (7.4) |
| Transfer Mode Select Lever Bolts | 115 (13) |
| Upper-To-Lower Valve Body Bolts | 57 (6.4) |
| Valve Body-To-Case Bolts | 89 (10) |