Diagnosis Procedure

Regarding Wiring Diagram information, refer to HEADLAMP: WIRING DIAGRAM (without DTRL) or DAYTIME LIGHT SYSTEM: WIRING DIAGRAM (with DTRL).

DIAGNOSIS PROCEDURE CHART

Step	Action	YES	NO
1	CHECK HEADLAMP (HI) FUSES Turn the ignition switch OFF. Check that the following fuses are not open. Is the fuse open?	Repair the harness and replace the fuse.	GO TO 2
2	CHECK HEADLAMP (HI) OUTPUT VOLTAGE Turn the ignition switch OFF. Courtesy of SUZUKI OF AMERICA CORP. 2. Disconnect the front combination lamp connector E11 or E107. 3. Turn the ignition switch ON. 4. Turn the high beam headlamps ON. 5. With the high beam headlamps ON, check the voltage between the combination lamp connector and ground. Courtesy of SUZUKI OF AMERICA CORP. Is battery voltage present?	GO TO 4	GO TO 3
3	CHECK HEADLAMP (HI) CIRCUIT FOR OPEN Turn the ignition switch OFF. Courtesy of SUZUKI OF AMERICA CORP. 2. Disconnect IPDM E/R connector E123. 3. Check continuity between the IPDM E/R harness connector (A) and the front combination lamp harness connector (B). Courtesy of SUZUKI OF AMERICA CORP. Does continuity exist?	Replace IPDM E/R. Refer to [IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE ROOM): REMOVAL AND INSTALLATION ].	Repair the harnesses or connectors.
4	CHECK FRONT HEADLAMP (HI) GROUND CIRCUIT Check continuity between the front combination lamp harness connector terminal and ground. Does continuity exist?	Inspect the headlamp bulb.	Repair the harness.
5	CHECK CONTINUITY BETWEEN FRONT HEADLAMP LH (HI) AND DAYTIME LIGHT RELAY 1 Disconnect daytime light relay 1 connector. Check continuity between front headlamp LH harness connector and daytime light relay 1 harness connector. Does continuity exist?	GO TO 6.	Repair the harness or connector.
6	CHECK DAYTIME LIGHT RELAY 1 GROUND CIRCUIT Check continuity between daytime light relay 1 harness connector and ground. Does continuity exist?	GO TO 7.	Repair the harness or connector.
7	CHECK DAYTIME LIGHT RELAY 1 Check daytime light relay 1. Refer to [Daytime Light Relay Circuit Check ] Is the inspection result normal?	Inspect the headlamp bulb.	Replace daytime light relay 1.