Combination Meter: Installation

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the combination meter assembly.
1. Connect each connector.
2. Install the combination meter assembly.
Install the visor assembly.
Install the cover steering UPR.
Install the panel start switch assembly. (Model with keyless access with push button start) Ref. to SECURITY AND LOCKS>PUSH BUTTON IGNITION SWITCH>INSTALLATION .
Install the cover start switch. (Model without keyless access with push button start)
Install the panel assembly center. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CLUSTER>INSTALLATION .
Install the driver monitoring unit. (Model with driver monitoring system) US Ref. to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT>INSTALLATION .
NOTE: For the model without driver monitoring system, install the cover assembly driver monitor in the same procedure as for the driver monitoring unit.
Install the light holder driver.
Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
Install the ornament panel mid driver assembly. Ref. to AIR CONDITIONER>AIR VENT GRILLE>INSTALLATION>SIDE GRILLE .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
When the combination meter assembly was replaced, perform the variant work. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>REPLACEMENT>VARIANT WORK .
When the combination meter assembly has been replaced, read the [Combination Meter] customizing information. Ref. to COMBINATION METER (DIAGNOSTICS)>CUSTOMIZE .