LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2025 >> Impreza Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Push Button Ignition Switch >> Installation

Push Button Ignition Switch: Installation

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Install the push button start switch.
  2. Install the panel start switch assembly.
    1. Connect the connector.
    2. Install the panel start switch assembly.
  3. Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
  4. Install the panel assembly center. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CLUSTER>INSTALLATION .
  5. Install the driver monitoring unit. (Model with driver monitoring system) Ref. to INSTRUMENTATION/DRIVER INFO>DRIVER MONITORING UNIT>INSTALLATION .
    NOTE: For the model without driver monitoring system, install the cover assembly driver monitor in the same procedure as for the driver monitoring unit.
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals