LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seat System - Seats >> Seat Heater >> Removal >> Seat Heater Unit >> Rear Seat

Rear Seat

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed. 
  1. Prior to starting work, check the following precautions. Ref. to SEATS>GENERAL DESCRIPTION>CAUTION 
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  3. Remove the rear seat. Ref. to SEATS>REAR SEAT>REMOVAL 
  4. Remove the rear seat surface. Ref. to SEATS>REAR SEAT>DISASSEMBLY 
  5. Remove the seat heater unit.
    CAUTION:
    • If the seat heater unit is removed, replace the seat pad assembly with a new part. 
    • If the seat heater unit is reused, remove the polyurethane section and double-sided tape from the reverse side completely. Use new double-sided tape. 

      Preparation items: 

      Double-sided tape: NITTO DENKO 501L or equivalent 

scientia non olet · About LEMON Manuals