LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> WRX Premium, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seat System - Seats >> Seat Heater >> Installation >> Seat Heater Unit >> Rear Seat

Rear Seat

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to  AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION 
  • Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed. 
  1. Install the seat heater unit in a new seat pad assembly.
    CAUTION:

    If the seat heater unit is reused, remove the polyurethane section and double-sided tape from the reverse side completely. Use new double-sided tape. 

    Preparation items: 

    Double-sided tape: NITTO DENKO 501L or equivalent

  2. Install the rear seat surface. Ref. to SEATS>REAR SEAT>ASSEMBLY 
  3. Install the rear seat. Ref. to SEATS>REAR SEAT>INSTALLATION 
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About LEMON Manuals