LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2022 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center >> Combination Meter >> Removal

Combination Meter: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. When the combination meter assembly is replaced with a new part, perform the variant work. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER>REPLACEMENT>VARIANT WORK .
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.
  4. Remove the cover LWR driver INN and cover LWR driver OUT. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  5. Remove the cover assembly instrument panel side RH and the panel center UPR assembly. Ref. to AIR CONDITIONER>AIR VENT GRILLE>REMOVAL>CENTER GRILLE .
  6. Remove the grille ventilation side LH. Ref. to AIR CONDITIONER>AIR VENT GRILLE>REMOVAL>SIDE GRILLE .
  7. Remove the visor assembly LWR.
    1. Release the claws of the column cover UPR.
      G16527051Courtesy of SUBARU OF AMERICA, INC.
    2. Release the clips and pull out the visor assembly LWR.
      G16527052Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the connector, and remove the visor assembly LWR.
  8. Remove the combination meter assembly.
CAUTION: Be careful not to damage the meter glass or instrument panel.
  1. Release the screws and clips and pull out the combination meter assembly.
    G16527053Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the connector and remove the combination meter assembly.
scientia non olet · About LEMON Manuals