LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Emission Control Systems (Aux. Emission Control Devices) (2.0L) >> PCV Hose Assembly >> Replacement >> PCV Hose ASSY No. 2

PCV Hose ASSY No. 2

  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the oil catch tank. Refer to INTAKE (INDUCTION) (W/O STI)>OIL CATCH TANK>REMOVAL .
  3. Remove the clamp cover.
    G11266565Courtesy of SUBARU OF AMERICA, INC.
  4. Break the clamp, and remove the PCV hose assembly No. 2 from the oil catch tank.
    G11266566Courtesy of SUBARU OF AMERICA, INC.
  5. Install the PCV hose assembly No. 2 to the oil catch tank, and install the clamp using the Clamp pincer (14100134).
    NOTE: Use a new clamp.
    G11266568Courtesy of SUBARU OF AMERICA, INC.
  6. Install the clamp cover.
    CAUTION: Be careful not to allow the lower part of the clamp cover to ride over the PCV hose assembly No. 2.
    G11266569Courtesy of SUBARU OF AMERICA, INC.
  7. Install the oil catch tank. Refer to INTAKE (INDUCTION) (W/O STI)>OIL CATCH TANK>INSTALLATION .
  8. Connect the ground terminal to battery sensor. Refer to NOTE>NOTE>BATTERY .
scientia non olet · About LEMON Manuals