LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Intake System (Induction) And Turbocharger (2.0L) >> Oil Catch Tank >> Removal

Oil Catch Tank: Removal

  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the air intake duct. Refer to INTAKE (INDUCTION) (W/O STI)>AIR INTAKE DUCT>REMOVAL .
  3. Unlock the blow-by diagnosis connector, and disconnect the PCV hose assembly No. 2 from the PCV hose assembly No. 1.
    G11266560Courtesy of SUBARU OF AMERICA, INC.
  4. Lift up the vehicle.
  5. Remove the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  6. Disconnect the oil hose from the oil pipe, and drain the engine oil in the oil catch tank.
    NOTE: Prepare the container for draining of engine oil.
    G09480125Courtesy of SUBARU OF AMERICA, INC.
  7. Remove bolts which secure the oil catch tank to the turbocharger and exhaust stay, and remove the oil catch tank.
    G09480126Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the oil hose from the oil catch tank.
scientia non olet · About LEMON Manuals