LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Entertainment System >> Antenna >> Removal >> Antenna Feeder Cord

Antenna Feeder Cord

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Refer to NOTE>NOTE>BATTERY .
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the cover assembly - instrument panel LWR driver. Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  3. Remove the knee airbag module. Refer to AIRBAG SYSTEM>KNEE AIRBAG MODULE>REMOVAL .
  4. Remove the glove box. Refer to EXTERIOR/INTERIOR TRIM>GLOVE BOX>REMOVAL .
  5. Remove the center grille assembly. Refer to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>AIR VENT GRILLE>REMOVAL>CENTER GRILLE ASSEMBLY .
  6. Remove the audio assembly or navigation assembly. Refer to ENTERTAINMENT & MONITORING>AUDIO>REMOVAL .
  7. Remove the panel center LWR LH. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
  8. Remove the cover side sill - front and the cover side sill - front INN. Refer to EXTERIOR/INTERIOR TRIM>LOWER INNER TRIM>REMOVAL .
  9. Lower the trim panel - roof assembly in the same manner as the removal procedure of the antenna assembly - radio or telematics. Refer to EXTERIOR/INTERIOR TRIM>ROOF TRIM>REMOVAL .
  10. Turn over the floor mat, and remove the cord assembly - antenna feeder.
scientia non olet · About LEMON Manuals