LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Lower Inner Trim >> Removal

Lower Inner Trim: Removal

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • Airbag system satellite safing sensor is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.
  1. Release the claws, and then remove the cover side sill - front INN.
    CAUTION: Do not pull with excessive force. Doing so may damage the claws of the cover side sill - front INN.
    G09489063Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the clips, and remove the cover side sill - front.
    G08316354Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the rear seat cushion assembly. Refer to SEATS>REAR SEAT>REMOVAL .
  4. Release the clips and claws, and then remove the cover side sill - rear INN.
    CAUTION: Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN.
    G13649519Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the trim panel - center pillar LWR.
    1. Release the clip by pulling the trim panel - center pillar LWR toward you.
    2. Expand the claws of the trim panel - center pillar LWR outward, and remove it from the trim panel - center pillar UPR.
      CAUTION: Do not expand the trim panel - center pillar LWR excessively. Doing so may damage the trim.
      G08316399Courtesy of SUBARU OF AMERICA, INC.
      NOTE: First release the claw located to the front of the vehicle.
  6. Disconnect the claws and remove the cover - catcher.
    G08319467Courtesy of SUBARU OF AMERICA, INC.
    NOTE: Remove the cover - catcher by using a plastic remover.