Charging Inlet

WARNING: This page is about a different variant/trim than selected.

WARNING: The hybrid system includes a high voltage circuit. Mishandling could cause accidents such as electric shock or leak. Always check "WARNING (HYBRID SYSTEM)" and perform the proper operation. Ref. to PRECAUTION/WARNING>WARNING (HYBRID SYSTEM) .

CAUTION: Airbag system satellite safing sensor is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

Install the cable EV charger lock assembly.
WARNING: Be sure to wear insulated gloves.

CAUTION: Make sure the connector is connected securely.

Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the bumper face - rear. Ref. to EXTERIOR/INTERIOR TRIM>REAR BUMPER>INSTALLATION .
Install the charge lid lock with motor assembly and the saucer SUB-assembly. Ref. to HYBRID ELECTRIC VEHICLE>CHARGE INLET>INSTALLATION>CHARGING INLET DOOR .
Remove the duct assembly - cooling out LH. Ref. to HYBRID ELECTRIC VEHICLE>HIGH VOLTAGE BATTERY COOLING SYSTEM>INSTALLATION>REAR DUCT .
Install the battery cooling blower assembly LH. Ref. to HYBRID ELECTRIC VEHICLE>HIGH VOLTAGE BATTERY COOLING SYSTEM>INSTALLATION>COOLING BLOWER .
Install the duct - battery cooling blower LH. Ref. to HYBRID ELECTRIC VEHICLE>HIGH VOLTAGE BATTERY COOLING SYSTEM>INSTALLATION>FRONT DUCT .
Install the trim panel - rear apron LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>INSTALLATION .
Install the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>INSTALLATION .
Install the service disconnect plug. Ref. to HYBRID ELECTRIC VEHICLE>SERVICE PLUG>INSTALLATION .
Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .