DTC P05C0: Active Grille Air Shutter Module "A" Over Temperature: Notes

WARNING: This page is about a different variant/trim than selected.

1. -

DTC detecting condition:

Immediately at fault recognition

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO(HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK DTC .
1. Turn the ignition switch to OFF, and cool down the engine enough.
  NOTE: Cool down the engine unit until it can be easily touched by hand.
2. Turn the ignition switch to ON.
3. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
  Is DTC P05C0 displayed? (Current malfunction)
  
  Yes: Replace the active grille shutter. Ref. to COOLING (H4DO(HEV))>ACTIVE GRILLE SHUTTER .
  
  No: Even if DTC is detected, the circuit has returned to a normal condition at this time.
  
  NOTE: In this case, there may have been a temporary rise of the temperature in the engine compartment.