LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (HVAC System (Heater, Ventilator And A/C) (Except For HEV)) >> In-Vehicle Sensor (Auto A/C Model) >> Removal

In-Vehicle Sensor (Auto A/C Model): Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, disconnect the battery negative terminal.
  2. Remove the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  3. Remove the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>REMOVAL .
  4. Remove the in-vehicle sensor.
    1. Disconnect the aspirator hose and connector.
      G11245701Courtesy of SUBARU OF AMERICA, INC.
    2. Release the claws and remove the in-vehicle sensor.
      G11245702Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals