LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim And Interior Trim >> Cowl Panel >> Removal

Cowl Panel: Removal

  1. Remove the arm assembly windshield wiper. Ref. to WIPER AND WASHER SYSTEMS>Front Wiper Arm>REMOVAL .
  2. Release the clips and claws, and then remove the right and left cowl panel sides.
    CAUTION: Pulling with excessive force may damage the cowl panel side. If it is difficult to remove, use a plastic remover or equivalent tool  .
    G13201570Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the cowl panel assembly.
    CAUTION:
    • Before removing the cowl panel, use an air blower and nylon brush to sweep gravel from the lower area of the front side of the glass  .
    • When removing the clip from the cowl panel center, push the claw of the clip from both sides  .
      • Be careful not to apply excessive force when pulling the clip, as the clip may become damaged  .
      • If pushing the claw of the clip is difficult, turning the claw position will facilitate the operation  .
    G11246496Courtesy of SUBARU OF AMERICA, INC.
    1. Disconnect the washer hose.
    2. Remove the clip.
    3. Remove the cowl panel assembly by pulling it out towards the front of the vehicle.
      G13201572Courtesy of SUBARU OF AMERICA, INC.
    4. Remove the washer nozzle and washer hose as required. Ref. to WIPER AND WASHER SYSTEMS>Front Washer Nozzle and Hose>REMOVAL .
scientia non olet · About LEMON Manuals