Diagnostic Procedure with ECU Cancel Code: 14

Detected when the select lever is shifted to the neutral position, or when an error related to the neutral

position switch occurs.

Trouble symptom: 

Cruise control cannot be set.

Wiring diagram: 

EyeSight system Ref. to WIRING SYSTEM>EyeSight System>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK INHIBITOR SWITCH CIRCUIT  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the inhibitor switch connector.
   3. Turn the ignition switch to ON.
   4. Measure the voltage between connector terminal and chassis ground.

      Connector and terminal 

      (T7) No. 6 (+) - Chassis ground (-):

      Is the voltage 10 V or more?

      Yes  : Go to  2.

      No 

      • Check the fuse.
      • Check for open or short circuit in the harness between inhibitor switch and ECM.
2. CHECK INHIBITOR SWITCH CIRCUIT  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the starter motor connector.
   3. Measure the resistance between the inhibitor switch connector terminal and the starter motor.

      Connector and terminal 

      (T7) No. 9 - Starter motor:

      Is the resistance less than 10 Ω?

      Yes  : Go to  3.

      No  : Repair the harness.

3. CHECK INHIBITOR SWITCH  .

   Remove and check the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>INHIBITOR SWITCH .

   Is the check result OK?

   Yes  : Replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Engine Control Module (ECM)>REMOVAL

   No  : Replace the inhibitor switch. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>INHIBITOR SWITCH .