LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Except For HEV) >> Heater Duct >> Removal >> Foot >> LH Side

LH Side

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Disconnect the ground terminal from the 12V engine restart battery sensor. and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the cover assembly - instrument panel LWR driver. Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  3. Remove the knee airbag module. Refer to AIRBAG SYSTEM>KNEE AIRBAG MODULE>REMOVAL .
  4. Remove the duct -  foot driver.
    1. Remove the screws securing the spacer -  foot and release the claws, then detach the duct -  foot driver together with the spacer -  foot.
      CAUTION: If the duct - foot is detached from the spacer - foot, replace the duct - foot with a new part. If the duct - foot is reused, the holding force of the claws and clips is reduced and the part may come off.
    G12395327Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals