LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Except For HEV) >> Heater And Cooling Unit >> Removal

Heater And Cooling Unit: Removal

CAUTION:
  • Before handling the airbag system components, refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  • Be careful not to damage the airbag system harness when servicing the instrument panel. Damage may cause the system to malfunction.
  • Seal the engaging parts of the disconnected hose, pipe and expansion valve - cooling with a plug or vinyl tape to prevent foreign matter from entering.
  1. Using the refrigerant recovery system. discharge refrigerant. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from the 12V engine restart battery sensor. and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Drain the coolant from the radiator. Refer to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Move the air intake boot. Refer to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>REMOVAL .
    NOTE: With the PCV hose connected, remove the air intake boot from the air cleaner case (rear) and throttle body.
  5. Remove the expansion valve - cooling. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>EXPANSION VALVE>REMOVAL .
  6. Disconnect the hose -  heater outlet and the hose -  heater inlet.
    1. Loosen the clamp, and detach the hose -  heater outlet.
    2. Loosen the clamp, and detach the hose -  heater inlet.
      G11245680Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Put alignment marks to hoses, clamps, etc.
  7. Remove the instrument panel assembly and the beam COMPL - steering. Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL ASSEMBLY>REMOVAL .
  8. Remove the duct - rear heater front. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>HEATER DUCT>REMOVAL>FRONT .
  9. Remove the duct - foot. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>HEATER DUCT>REMOVAL>FOOT .
  10. Remove the heater and cooling unit assembly.
    1. Remove the hose - drain.
    2. Remove the bolt and remove the heater and cooling unit assembly.
      G11245681Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals