LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC System (Heater, Ventilator And A/C) (Except For HEV) >> Evaporator Sensor >> Removal

Evaporator Sensor: Removal

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Using the refrigerant recovery system. discharge refrigerant. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from the 12V engine restart battery sensor. and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Drain the coolant from the radiator. Refer to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Remove the evaporator assembly - cooling. Refer to AIR CONDITIONER (EXCEPT FOR HEV)>EVAPORATOR>REMOVAL .
  5. Remove the evaporator sensor.
    1. Remove the evaporator sensor as shown in the figure.
    G11245706Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals