LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (P-HEV Hybrid Powertrain Control System (Diagnostics) (1 Of 2)) >> Inspection Mode >> Procedure >> Inspection Mode 26

Inspection Mode 26

WARNING: This page is about a different variant/trim than selected.
Code Note Number of driving cycles on the detecting condition
P314779 - 1

Diagnostic procedure:

  1. Using the Subaru Select Monitor, perform the clear memory of [P-HEV Hybrid Powertrain Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
  2. Turn to IG OFF, and wait for two minutes or more.
  3. Using the Subaru Select Monitor, read the DTC of [P-HEV Hybrid Powertrain Control] to check that there is no DTC displayed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step  1.
  4. Depress the accelerator pedal from the vehicle still to full throttle, and drive the vehicle for three seconds. At that time, check that the DTC is not displayed.
  5. Press Hybrid mode switch, and switch to the battery save mode.
    NOTE: When the HV warning indicator is on due to DTC detection for [P-HEV Hybrid Powertrain Control], [P-HEV Drive Motor] or [P-HEV High Voltage Battery], switching to the battery save mode is not possible. Therefore, inspect the detected DTCs first.
    When switching to the battery save mode is not possible due to a reason other than above, check "Unable to switch to each mode" in Diagnostics with Phenomenon. When the condition is confirmed as normal as a result of checking, proceed the inspection in normal mode. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTICS WITH PHENOMENON>LIST .
  6. Depress the accelerator pedal to start the engine, and drive the vehicle for two seconds or more.
  7. Read the [Readiness code] of [P-HEV Hybrid Powertrain Control] using Subaru Select Monitor and check that the concerned self-diagnosis is completed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>ALL READINESS DIAGNOSTIC CODE(S) .
    NOTE: If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete, repeat from step  4.
  8. Using the Subaru Select Monitor, read the DTC of [P-HEV Hybrid Powertrain Control] to check that there is no DTC displayed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
    NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.
scientia non olet · About LEMON Manuals