Inspection Mode 22
WARNING: This page is about a different variant/trim than selected.
| Code | Note | Number of driving cycles on the detecting condition |
|---|---|---|
| P212012 | - | 1 |
| P212014 | - | 1 |
| P21201C | - | 1 |
| P21201F | - | 1 |
| P212512 | - | 1 |
| P212514 | - | 1 |
| P21251C | - | 1 |
| P21251F | - | 1 |
| P213800 | - | 1 |
| P21382B | - | 1 |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [P-HEV Hybrid Powertrain Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Turn to IG OFF, and wait for two minutes or more.
- Using the Subaru Select Monitor, read the DTC of [P-HEV Hybrid Powertrain Control] to check that there is no DTC displayed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1.
- After waiting approximately 10 seconds with READY ON and P position, repeat the operation of accelerator pedal fully closed/fully open a few times.
- Read the [Readiness code] of [P-HEV Hybrid Powertrain Control] using Subaru Select Monitor and check that the concerned self-diagnosis is completed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>ALL READINESS DIAGNOSTIC CODE(S) .NOTE: If the concerned DTC is displayed, the self-diagnosis of the DTC is not complete, repeat from step 4.
- Using the Subaru Select Monitor, read the DTC of [P-HEV Hybrid Powertrain Control] to check that there is no DTC displayed. Ref. to P-HEV HYBRID POWERTRAIN CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.