Overview Of Error
WARNING: This page is about a different variant/trim than selected.
Hybrid vehicle control ECU assembly detects an ON malfunction due to the charge relay adhered or stuck on the positive side of HV battery.
The following are possible causes of the error.
- Fault of voltage sensor (VCHG) system in Electric vehicle charger assembly
- Voltage sensor (VCHG) malfunction
- Malfunction of Electric vehicle charger assembly
- Malfunction of communication (Wire harness)
- High voltage system fault
- Malfunction of HV battery junction block
- Low voltage system (12 V) fault
- Malfunction of Hybrid vehicle control ECU assembly
- Malfunction of HV battery junction block
- Malfunction of Battery ECU assembly
- Low voltage Wire harness malfunction
- Low voltage connector malfunction