LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (M/T Clutch System) >> Master Cylinder >> Removal

Master Cylinder: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground terminal from the 12V engine restart battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Drain the brake fluid. Ref. to CLUTCH SYSTEM>CLUTCH FLUID .
  4. Remove the instrument panel lower cover. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
  5. Remove the steering column. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>REMOVAL .
  6. Remove the clutch pedal assembly. Ref. to CLUTCH SYSTEM>CLUTCH PEDAL>REMOVAL .
  7. Remove the clip and clevis pin, and then remove the push rod of the master cylinder.
    G13604826Courtesy of SUBARU OF AMERICA, INC.
  8. Disconnect the clutch pipe.
    G11256384Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the master cylinder.
G13604828Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals