LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (SUBARU Eyesight System (Driver Assist) (Diagnostics) (HEV)) >> Diagnostics with Phenomenon >> Inspection >> Cruise Control Is Not Released After Brake Pedal Has Been Depressed

Cruise Control Is Not Released After Brake Pedal Has Been Depressed

WARNING: This page is about a different variant/trim than selected.
  1. PERFORM REAL TIME DIAGNOSIS  .

    Check the input signal of cruise control system. Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>REAL-TIME DIAGNOSIS .

    Is the check result OK?

    Yes  : The circuit has returned to a normal condition at this time.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No  : Go to  2.

  2. INSPECTION OF STOP LIGHT SWITCH AND BRAKE SWITCH  .

    Check stop light switch and brake switch. Ref. to BRAKE>BRAKE PEDAL . Ref. to EYESIGHT (DIAGNOSTICS) (HEV)>DIAGNOSTICS WITH PHENOMENON>INSPECTION>STOP LIGHT SWITCH OR BRAKE SWITCH IS TURNED TO ON, AND THEN THE CRUISE CONTROL IS RELEASED .

    Is the check result OK?

    Yes  : Replace the ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (HEV))>ENGINE CONTROL MODULE (ECM)>REMOVAL .

    No  : Repair or replace the faulty portion according to the inspection result.

scientia non olet · About LEMON Manuals