LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Hose and Pipe >> Removal >> Low Pressure Valve Hose

Low Pressure Valve Hose

WARNING: This page is about a different variant/trim than selected.
  1. Using the refrigerant recovery system, discharge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>REMOVAL .
  4. Remove the radiator assembly. Ref. to COOLING (H4DO (HEV))>RADIATOR>REMOVAL .
  5. Remove the hose - pressure suction valve.
    1. Remove the bolts and remove the hose - pressure suction valve.
      CAUTION:
      • Do not apply excessive force to the hose.
      • Seal the engaging parts of the disconnected hose and LOW solenoid valve with plugs or vinyl tape to prevent foreign matter from entering.
G13234307Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals