LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (HVAC System (Heater, Ventilator And A/C) (HEV)) >> Hose and Pipe >> Removal >> Cooling Pipe

Cooling Pipe

WARNING: This page is about a different variant/trim than selected.
  1. Using the refrigerant recovery system, discharge refrigerant. Ref. to AIR CONDITIONER (HEV)>REFRIGERANT RECOVERY PROCEDURE>PROCEDURE .
  2. Disconnect the ground terminal from battery. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the bumper face - front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>REMOVAL .
  4. Remove the radiator assembly. Ref. to COOLING (H4DO (HEV))>RADIATOR>REMOVAL ,
  5. Remove the inverter front water pipe.
    1. Remove the bolts and nuts, and remove the inverter front water pipe.
      G13234318Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the pipe -  evaporator cooling.
    1. Remove the bolt, clip, and clamp, and remove the pipe -  evaporator cooling.
      CAUTION:
      • Do not apply excessive force to the pipe.
      • Seal the engaging parts of the disconnected pipe, expansion valve - and cooler assembly, and LOW solenoid valve with plugs or vinyl tape to prevent foreign matter from entering.
      G13234319Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals