LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2020 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System (Service Information) >> Brake Pipe >> Removal >> Center Brake Pipe

Center Brake Pipe

  1. Perform the accumulator down drive. (Hybrid model) Refer to BRAKE>BRAKE SYSTEM>OPERATION>ACCUMULATOR DOWN DRIVE .
  2. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: For the hybrid model, disconnect the battery negative terminal.
  3. Lift up the vehicle, and then remove the rear wheels.
  4. Remove the crossmember support - rear RH. Refer to FRONT SUSPENSION>CROSSMEMBER SUPPORT>REMOVAL .
  5. Remove the fuel tank protector.
  6. Remove the floor under protector RH. Refer to EXTERIOR/INTERIOR TRIM>FLOOR UNDER PROTECTOR>REMOVAL .
  7. Remove the rear exhaust pipe. Refer to EXHAUST (H4DO (EXCEPT FOR HEV))>REAR EXHAUST PIPE>REMOVAL .
  8. Remove the propeller shaft assembly. Refer to DRIVE SHAFT SYSTEM>PROPELLER SHAFT>REMOVAL .
  9. Remove the rear differential.
  10. Remove the fuel tank.
  11. Remove the support - sub frame.
    G11255245Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the pipe assembly center.
    1. Separate each brake pipe using a flare nut wrench.
      • Except for hybrid model
        G13602755Courtesy of SUBARU OF AMERICA, INC.
      • Hybrid model
      G13602756Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the pipe assembly center.
scientia non olet · About LEMON Manuals